If the gas mold temperature controller is broken, it is actually because it will dry out, and it is because of this, we actually will directly set up two buttons on the circuit board, that is, The motor start button and its heater start button are precisely because of this, it will require the operator of the gas mold temperature machine to start the motor button first.

    In this respect, after the water on the gas mold temperature machine is completely replenished, we actually need to pay attention to the heater button. In this way, although it can prevent the heater from appearing to a certain extent The case of dry burning, but because this operation actually needs to be completed by humans, but because the operation is not user-friendly, we actually need to wait for a period of time and then process it.

    One of the important reasons for the damage of the heater of the gas mold temperature machine is that first of all, it actually refers to a quality of the heater itself. Furthermore, the other one is actually for the heater (electric heating tube). A series of dry burning conditions occur. If the water temperature heater is dry burning, it will actually use the best electric heating tube, which is actually useless.

    Why there is a series of dry burning phenomenon in the gas mold temperature, when the machine is turned on, the motor will actually start at the same time as the heater, and the heater will actually start working immediately.

    The temperature is increased during heating. Since the water has not yet entered the gas mold temperature machine when the motor is started, the heater actually does not have the medium of water. It is precisely because of this that the gas mold temperature machine is actually It will directly cause dry burning. Working for a long time like this, in fact, shortens the service life of the heater itself to a certain extent, causing frequent damage.