The following is a list of several common fault problems and solutions for mold temperature machines.

1. The cause of the burnout of the heating tube of the mold temperature machine: The important point is the quality problem of the heating tube, and the second is that the process has caused the air on the surface of the heating tube to cause the heating tube to dry. If it is configured in a good mold temperature machine, it cannot be dried. Solving the burning problem is also very easy to cause the problem of dry burning of the heating tube, so the mold temperature machine of Xinjiuyang Machinery is a process that has developed through nearly years of research and practice to develop a near-perfect media circulation, with the main components of internationally renowned brands. The quality of our company's mold temperature machine has become an excellent domestic level.

2. Why the heater of the oil-type mold temperature machine is dry burning: The main reason is that the mold temperature control machine is operated improperly, and the air in the mold temperature machine is not heated at the beginning of the use, which can be directly heated, resulting in the dry heating of the heating pipe of the mold temperature machine. burn. The heater will start working immediately: heating up, because the motor has just started, the water has not yet entered the machine, the heater does not have the medium of water, which leads to direct dry burning. Working for a long time like this shortens the life of the heater and makes the heater often easily broken.

Although some manufacturers have designed a plan for this, the circuit board has two buttons, namely the motor start button and the heater start button. This requires the operator to start the motor button first, wait for the water to be completely filled, and then operate the heater button. This can prevent the heater from burning dry, but because this operation needs to be done by humans, and the operation is not user-friendly, it needs to wait for a while and then process it. Many operators often turn on two buttons at the same time for convenience. The manufacturer's design intent cannot protect the heater.

The temperature of the oil heated by the mold temperature rises quickly, and there is no temperature in the oil return: it may be caused by the blockage of the pipeline. Method: disassemble the filter and clean it.