The mold temperature machine is an industrial temperature control device often used by most large modern companies, but the service life of the mold temperature machine of different users is quite different. This is because various failures may occur during the use of the mold temperature machine. After using for several years, some users will directly abandon the old equipment and re-purchase a brand new mold temperature machine, which will increase the company's operating expenses. So how to extend the service life of the mold temperature machine?

1. For the new mold temperature machine, we need to make different maintenance measures according to the thermal conductivity medium used. For the medium that is water, we must keep the water source clean, so that it is not easy to scale, and it can prevent the pipeline from being blocked; for the medium It is oil, and it should be changed according to the temperature of the body. For those above 200 ℃, it is necessary to see whether the oil is rare. It will be changed every 5 to 6 months, and we can change it once a year below 200 ℃, which is very So avoid the problem of scaling.

Second, formulate rules and regulations for the cleaning and maintenance of the mold temperature machine, and record each maintenance work performed. When cleaning the unit, it is not only a cleaning of the appearance, but also the main need is that the electrical components, filters, valves, etc. of the unit need to be cleaned every year to prevent impurities in the water quality from scaling and affecting the mold temperature. The machine is operating normally.

3. When using the mold temperature machine, the operator should always pay attention to the use of the unit. If there is abnormal noise or some faults in the circulating pump, I must shut down in time to prevent damage to the motor. And troubleshoot according to the fault display in the control panel of the mold temperature machine. When the fault has not been eliminated, remember not to start the mold temperature machine.

4. Change the thermal oil according to the usage time of the oil mold temperature machine. The heat transfer oil is used as the heat transfer medium of the mold temperature machine, and its performance affects the working efficiency of the mold temperature machine. If the heat transfer oil has serious carbon deposition, it will not only affect the service life of the hot pipe, but also cause power consumption. It is recommended to check the condition of the heat transfer oil every six months and change it in time.

Fifth, the operator of the mold temperature machine should record all the data during the operation of the device group in the dead time, so that it can be easily viewed afterwards, and the components of the device group need to be tested after long-term use. Make sure it works. When the captain of the mold temperature does not need to run when it is needed, the heat conduction oil inside the device group and the pipe channel should be cleaned to prevent damage to the components of the device group.

6. After each use, the mold temperature machine should be cleaned up briefly to prevent the accumulation of dust and affect the operation of the mold temperature machine. How to extend the service life of the mold temperature machine is shared here. In addition, the reasonable and correct operation of the mold temperature machine is very important and needs. This is not only related to the performance of the mold temperature machine equipment, but also related to the safety of the equipment and the person. Therefore, you need to be cautious about the operation of the mold temperature machine, and carry out operation and maintenance according to the instructions to extend the service life of the mold temperature machine.